Bio Limousin Moteur de recherche

off the computer, monitor and any attached peripheral devices. Unplug the power cord from the rear panel of the computer. Disconne ct any cables attached to the interface ports on the front and rear panels. Press the power button on the front panel. Move the co mputer over to a stable work surface. 2 Tilt the computer over onto the left-side panel. Locate the latch installed in the rear ed ge of the right side panel. Slide the latch and lift the upper edge of the right side panel free of the computer case. Pull the bo free design templates ttom edge of the right side panel free. Set the right-side panel aside. 3 Find the sliding plate installed on the side of the driv e bays, near the front panel of the computer. Slide the plate toward the rear panel and remove the drive panel from the front of t Bio Limousin Moteur de recherche he computer. Select an empty drive bay to hold the DVD burner. 4 Inspect the back of the drive panel and locate the attached screw .

nd locate the diagram indicating the various jumper settings. Set the jumpers to the setting labeled cable or CS. Slide the rear e nd of the DVD burner through the front panel and into the empty drive bay. 6 Select one of the unused power cables connected to th e power supply. Plug the cable into the power port on the rear of the DVD burner. Locate an unused connector on one of the data ca bles connected to the motherboard. Plug the connector into the matching port on the rear of the burner. 7 Tuck the power and data cardboard texture cables into the case. Reinstall the drive panel and press it into the front panel until you feel it snap into place. Inspect the b ottom edge of the right side panel and locate the three tabs. Insert the tabs into the slots on the bottom edge of the computer ca Bio Limousin Moteur de recherche se. Press the top edge of the right side panel against the computer case until you feel the panel snaps into place. 8 Return the c .

your existing router from your cable modem, DSL modem or other upstream Internet connection. 2 Turn your cable or DSL modem off, wait for two minutes and then turn it on again. This resets its internal memory for network address allocations. 3 Connect your ha rdware firewalls data in or Internet in port to your cable or DSL modems data out or Internet out port and turn it on. 4 Connect a computer to the firewall with an Ethernet cable. 5 Open a web browser and connect to the firewalls administrative control panel. South Beach Diet Instructions for doing this are in the firewalls manual; typically, you point a web browser to http:192.168.1.1 and enter the defa ult username and password. 6 Set a new username and password for the firewall; this is usually on the first administrative screen Bio Limousin Moteur de recherche of the firewall. 7 Choose the tab for port blocking or port filtering. A table will appear which allows selective blocking of Inte .

Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche