Bio Limousin Moteur de recherche

a static-free surface. 5 Remove the four Phillips screws that secure the AirPort card retainer and lift the retainer out of the co mputer. Pull the keyboard-ribbon cable connector straight up to disconnect and remove the keyboard. 6 Close the computer display a nd flip the iBook over. Use a T8 Torx screwdriver to remove the three screws in the bottom case, two near the front edge and anoth er about six inches behind them. Use a small flat-blade screwdriver to pry off the three rubber foot-pads from the corners of the dental office newsletter template free base. Use a Phillips screwdriver to remove the three feet. Remove the two Phillips screws from the inside edge of the battery bay. 7 Grasp the corner of the bottom case nearest the hard drive bay and lift it slightly. Insert a flat-blade screwdriver into the s Bio Limousin Moteur de recherche lot on the rear edge of the battery bay and release the latch. Use the screwdriver to pry around the edge of the bottom case until .

left-rear corner of the computer. Lift the metal bottom shield off the computer. 9 Remove the yellow tape from the DC-In board in the left-rear corner of the computer and remove the two Phillips retaining screws. Unplug the DC-In-board cable connector from th e motherboard. Grasp the edges of the board and lift it up off the computer. 10 Remove the two Phillips screws from the left corne r of the battery bay. Turn the computer over and open the display. Remove the seven Phillips top-cover screws. There are three alo best free psd website templates ng the rear of the top shield, three along the front of the top shield and one on the right edge. To access the center-rear screw, first pry off the magnet that covers it. 11 Start at the edge nearest the battery bay and pry the top cover off the base, working Bio Limousin Moteur de recherche your way around the front edge until you can flip the cover up to access the cables beneath it. Disconnect the two cables from th .

n the left side and one forward of the center opening in the shield. 13 Turn the computer over and lift the hard-drive ribbon cabl e connector off the motherboard. If necessary, use a flat-blade screwdriver to gently pry it off. Turn the computer back over and remove the two Phillips hard-drive retaining screws. Lift the hard drive out of the computer base. 14 Pull the hard drive out of i ts aluminium bracket. Grasp the tab on the hard-drive cable and pull it off the drive. Installation 15 Remove the two screws from download free wedding css templates each side of the old hard drive and transfer them to the replacement drive. Connect the cable to the new drive and insert it into the bracket. 16 Insert the hard drive into its bay and replace the two screws. Route the cable through the slot in the bottom of t Bio Limousin Moteur de recherche he bay. Place the metal top shield on the computer and replace the 15 screws that hold it in place. 17 Place the top cover on the .

Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche