Bio Limousin Moteur de recherche

the Enter OS Load Options blank. 8 Restart your computer. Windows will now start normally.1 Plug a Cisco serial cable from a compu ter to the ASA 5505. Open a terminal console program such as Hyperterminal or Putty Microsoft Windows, or Minicom Linux and select the com port in use by the Cisco serial cable. Press the Enter key to receive a prompt response from the ASA 5505. Type in an acc ount name and password if required to log in. 2 Test connectivity from the ASA 5505 to the Syslog server by typing the following o online books for free n the ASA 5505 command line interface:ASA5505 enableASA5505 password:ASA5505#ping 10.0.0.1and press Enter. Enter the specific enab le password for the ASA 5505 when requested and replace the 10.0.0.1 with the IP address of your Syslog server. If connectivity is Bio Limousin Moteur de recherche established the terminal will display the following:Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.0.0.1, tim .

gain. 3 Type config t on the ASA 5505 command line. Press Enter to access configuration mode. The command prompt should now look s imilar to the following:ASA5505 config #where config indicates that the context has changed to configuration mode. 4 Type ��loggin g enable on the command line, and press the Enter key. This will activate the logging service on the ASA5505. 5 Configure the ASA 5505 to send log messages to a specific Syslog server. While you are still in configuration mode, on the command line, use the fol photography website templates lowing syntax to specify the Syslog server where the log messages will be recorded:logging host interface name IP_address TCPport_ number UDPport_numberand press the Enter key. Follow the format of this example:ASA5505 config #logging host inside 10.20.20.10In Bio Limousin Moteur de recherche the example above, ��inside is the name of the interface out of which the log messages will be sent and 10.20.20.10 is the IP addr .

level names and numbers are:0 = emergencies1 = alerts2 = critical3 = error4 = warning5 = notification6 = informational7 = debuggi ngThe higher the severity level number, the more verbose the messages. As a general rule, configuring severity to 3, or error, is the best balance to ensure that necessary messages are received while suppressing unnecessary messages that consume storage space. The command to specify the Syslog message severity level must be entered in configuration mode following the syntax below:logging metal background trap severity_levelSeverity level can be specified either by name or by number. Here is an example command line severity level co nfiguration:ASA5505 config #logging trap 3The new configuration is now held in memory. 7 Save the configuration by exiting from co Bio Limousin Moteur de recherche nfiguration mode, and save the memory to non-volatile memory or NVRAM. Type exit and press then Enter key and then type copy run s .

Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche | Bio Limousin Moteur de recherche